https://forms.gle/HWrQePUxW ...
Dear All,
We have Opening for the below mentioned categories.
T&C Engineer
Scope of Work :
To work as a T&C Engineer to ensure the safe operation and supervision of the
Substations and various renewable Power Plants from the T&C Control Room from postenergization until the final project handover period.
The T&C Control Engineer shall be responsible for the safe, reliable, and efficient
operations of microgrid and associated substations from the T&C Control Room.
1.Job Responsibilities:
• Directing and/or executing switching operations through Switching Engineers in
accordance with the approved Switching Program.
• Supervising and monitoring all connected substations from the T&C Control
Room.
• Operating and maintaining the 380 kV and 33 kV microgrid in compliance with SEC
Grid Code and applicable standards.
• Controlling system load flow and maintaining tie-line power exchange between
the microgrid and SEC substations.
• Maintaining system voltage and frequency within permissible limits.
• Releasing and restoring circuits as per operational and maintenance
requirements.
• Ensuring continuous monitoring, alarm management, and data recording for all
energized substations on a 24/7 basis.
• Coordinating with stakeholders to ensure reliable and uninterrupted system
operation.
System Operation & Control
• Ensure safe, secure, and reliable operation of the electricity generation,
transmission, and distribution network.
• Execute and supervise switching operations strictly as per approved procedures
and switching programs.
• Enforce Permit-to-Work (PTW) and LOTO safety protocols at all times.
Sensitivity: LNT Construction Internal Use
• Prevent unsafe switching and ensure operational discipline, respond immediately
to Line trips, Generation outages, Transformer, busbar, and line faults
• Perform fault isolation and system restoration.
• Coordinate with Protection Engineers, Field Operators, and SEC Load Dispatch
Center.
• Coordinate with Power plants (PV, Wind, BESS, etc.), SEC Control Centres,
Transmission operators to ensure compliance with dispatch instructions such as
Load increase/decrease, Reactive power control, Voltage regulation.
• Maintain system frequency (e.g., 60 Hz) and voltage profile within limits.
• Monitor and control load flow to ensure grid balance.
• Take corrective actions like manual load shedding (if required), Switching of
reactive compensation devices (e.g., STATCOM)
• Prevent grid disturbances, cascading failures, and blackouts.
• Ensure all maintenance activities are carried out under valid PTW.
• Verify Proper isolation of equipment, earthing application, absence of back-feed
risks
• Maintain strict adherence to safety procedures.
• Maintain Shift logbooks, Event and trip records, Switching logs
• Record all alarms, events, and corrective actions taken.
• Prepare and submit daily alarm reports (including pending alarms at 12:00 AM),
Fault reports, Operational and performance reports
• Share reports with management and relevant stakeholders.
• Participate in system restoration during grid collapse/blackout conditions.
• Support sequential energization of transmission lines and renewable generation
sources.
• Identify and report abnormalities observed through T&C.
2. Qualification & Experience
• Bachelor’s Degree (or equivalent) in Electrical / Electronic Engineering from a
reputed university.
• Minimum 5 years of relevant experience in power system operations within a utility
or large infrastructure project.
Sensitivity: LNT Construction Internal Use
• At least 3 years of supervisory experience, preferably in T&C / SCADA-based
control systems.
• Strong knowledge of international standards and SEC standards, codes, and
practices.
• Proven experience in:
1. T&C Control Room operations
2. Switching procedures and safety protocols
3. Commissioning of MV / HV / EHV equipment
• Good understanding of power system safety rules, including LOTO and permit
systems.
• Fluency in English (written and spoken) is mandatory.
• Knowledge of Arabic is an added advantage.
• Willingness to work in shift duties (2 or 3 shifts).
• SAP (Senior Authorized Person) certification from SEC or other utilities is
preferred.
• Must successfully pass the technical interview and assessment.
* Ready to relocate
* Immediate joining
Long-term project
FAT by company
Kindly please send your CV here
https://forms.gle/HWrQePUxW ...