I am Syed Sameer, a CSWIP 3.1 certified Welding Inspector with a Diploma in Mechanical Engineering and over 4 years of experience in oil & gas, petrochemical, and fabrication projects in Saudi Arabia and India.
I hold ASNT Level II certifications in RT, UT, DPT, and MPT and have strong knowledge of ASME, AWS, API, and Saudi Aramco standards. My experience includes WPS/PQR/WQR review, NDT coordination, PMI monitoring, weld defect identification, and preparing inspection reports and NCRs.
Pre-Welding (Preparation)
· Review and approve WPS (Welding Procedure Specification) and welder certifications
· Verify base metals, filler metals, and fluxes match project requirements
· Check material heat numbers against Mill Test Reports (MTRs)
· Inspect joint fit-up: alignment, bevel angle, root gap, and tack welds
In-Process (Monitoring)
· Monitor welding parameters: amperage, voltage, travel speed, gas flow
· Check and record preheat and interpass temperatures
· Observe welding technique and interpass cleaning
· Ensure compliance with approved WPS at all times
Post-Welding (Verification)
· Perform visual inspection for surface defects (cracks, porosity, undercut, lack of fusion)
· Interpret NDT results (UT, RT, MT, PT)
· Measure weld dimensions: reinforcement height, fillet leg length
· Verify post-weld heat treatment if required
Documentation & Compliance
· Maintain daily inspection logs and weld maps
· Issue Non-Conformance Reports (NCRs) for defects
· Track corrective actions and rework
· Compile final quality dossier for project handover
· Exercise stop-work authority for unsafe or non-compliant work
I am currently based in Dammam, Saudi Arabia, with a transferable Iqama, and am available immediately.
I would welcome the opportunity to discuss how my skills can benefit your team.